remember panel widths?

Guest · Post by **Guest** » Tue Apr 05, 2005 3:37 pm

Post by **Karlis** » Wed Apr 06, 2005 11:11 pm

This should work and it works as far as we have tested.

However there have been several issues with this caused by non-standard screen resolutions, if you believe this is your case, please report more info about your screen resolution, font size and the amount of error (in pixels) that occurs.

Guest · Post by **Guest** » Fri Apr 08, 2005 5:06 am

mee too!
my screen is 1400x1050 sony LCD
the panels always go narrow
esp file panel i have to scroll all right

Post by **Karlis** » Sun Apr 10, 2005 11:57 pm

Mine HP too, but I can not reproduce it.

Will try to find out what and why...

blurble · Post by **blurble** » Mon Jan 23, 2006 9:25 pm

I also have this problem. Whenever I load WeBuilder the panels are shown the default width, rather than the width I set them at.
If I save a layout with the panels set to the width I want, then reload them, they are set to the default, thinner, size, not the size I set.
I have Code Explorer, File Explorer, Inspector, Objects and Markup all as tabs on the right side of the screen, and no panels on the left.

I find this very annoying, as I have to resize the panels every time I start WeBuilder.

Post by **Karlis** » Sun Jan 29, 2006 4:51 pm

Does the size change drastically or only a little bit? Try to open, close it several times.